Versions Compared


  • This line was added.
  • This line was removed.
  • Formatting was changed.

Run vcld -setup

  1. Run the following command on the management node:


    /usr/local/vcl/bin/vcld --setup

  2. Navigate the menu options
    (Note: the names and numbers of the menu items may not match your installation):
    1. Select a module to configure: VCL Image State Module
    2. Choose an operation: Image Management → Capture Base Image
    3. Enter the VCL login name or ID of the user who will own the image:
      Enter your VCL user ID or the user ID of the user you want to own the image.  Pressing Enter without entering a user login ID will cause admin to be the owner of the new base image.
    4. Enter the hostname or IP address of the computer to be captured:
      Enter the name or private IP address of the computer which has already added to the VCL database.
    5. Select the OS to be captured (NOTE in the list, VMware means virtual and is not specific to the VMware hypervisor):
      1. Generic Linux (VMware Linux)
      2. OSX Snow Leopard (VMware)
      3. Ubuntu (VMware)
      4. Windows 10.x (VMware)
      5. Windows 2003 Server (VMware)
      36. VMware Windows 7
      4. VMware (VMware)
      7. Windows 8.x (VMware)
      8. Windows Server 2008 (VMware)
      59. Windows Server 2012 (VMware)
      10. Windows Server 2016 (VMware)
      11. Windows Vista (VMware)
      612. Windows XP (VMware ESX)
      13. Windows XP (VMware)
    6. Image architecture:
      1. x86
      2. x86_64
    7. Use Sysprep:
      1. Yes
      2. No
      Sysprep is usually only required if the image will be loaded on bare metal computers with varying different hardware.
    8. Enter the name of the image to be captured:
      The name you enter is the name that will be displayed in the list of environments.  It may contain spaces but including other special characters is not recommended.


  • A new image is added to the VCL database
  • An imaging request is added to the VCL database
  • The vcld -setup automatically initiates 'tail -f /var/log/vcld.log' to monitor the vcld log file.  The output should will be displayed on the screen for several seconds and then tail will be stopped. However, the capture process will continue. Manually running 'tail -f /var/log/vcld.log' will allow you to continue monitoring the capture process.

Watch the vcld logfile output to determine if the image capture process is successful or terminated because a problem occurred.  When the capture process terminates, there will either be a message near the end of the output saying "image capture successful" or there will be several WARNING messages, the last of which says something to the effect "image failed to be captured".  Further troubleshooting is required if the image fails to be captured.