camel-test JAR is using JUnit. There is an alternative
camel-testng JAR (from Camel 2.8) using the TestNG test framework.
Adding to your
To get started using Camel Test you will need to add an entry to your
Available as of Camel 2.8
You might also want to add
log4j to ensure nice logging messages (and maybe adding a log4j.properties file into your
Writing your test
You firstly need to derive from the class
org.apache.camel.testng.CamelTestSupport for JUnit 3.x, JUnit 4.x, and TestNG, respectively) and typically you will need to override the
createRouteBuilders() method to create routes to be tested.
Here is an example.
Features Provided by
CamelTestSupport classes provide a standard set of behaviors relating to the
CamelContext used to host the route(s) under test. The classes provide a number of methods that allow a test to alter the configuration of the
CamelContext used. The following table describes the available customization methods and the default behavior of tests that are built from a
If the route builders returned from either
Its important to start the
Triggers the auto-mocking of endpoints whose URIs match the provided filter. The default filter is
If this method returns
are invoked for each processor in the registered routes.
The methods are not invoked during the test.
Returns the number of seconds that Camel should wait for graceful shutdown.
Useful for decreasing test times when a message is still in flight at the end of the test.
If JMX should be disabled on the
JMX is disabled
Provides a hook for adding objects into the registry. Override this method to bind objects to the registry before test methods are invoked.
An empty registry is initialized
Camel 2.10: Allows to add/override properties when Using PropertyPlaceholder in Camel.
Camel 2.10: Allows to control if Camel should ignore missing locations for properties.
Camel 2.16: If enabled, then Camel will dump all route coverage statistics into XML files in the target/camel-route-coverage directory. These XML files contains information about "route coverage" of all the routes that was used during the unit test. This allows tooling to inspect these XML files and generate nice route coverage reports.
Camel uses a Registry to allow you to configure Component or Endpoint instances or Beans used in your routes. If you are not using Spring or OSGi then JNDI is used as the default registry implementation.
So you will also need to create a
jndi.properties file in your
src/test/resources directory so that there is a default registry available to initialize the CamelContext.
Here is an example jndi.properties file
Dynamically Assigning Ports
Available as of Camel 2.7
Tests that use port numbers will fail if that port is already on use.
AvailablePortFinder provides methods for finding unused port numbers at run time.
Setup CamelContext once per class, or per every test method
Available as of Camel 2.8
The Camel Test kit will by default setup and shutdown CamelContext per every test method in your test class. So for example if you have 3 test methods, then CamelContext is started and shutdown after each test, that is 3 times.
This feature is also supported in
When using this the CamelContext will keep state between tests, so have that in mind. So if your unit tests start to fail for no apparent reason, it could be due this fact. So use this feature with a bit of care.
You may want to do this once, to share the CamelContext between test methods, to speedup unit testing. This requires the use of JUnit 4! In your unit test method you have to extend the
org.apache.camel.test.junit4.CamelTestSupport or the
org.apache.camel.test.junit4.CamelSpringTestSupport test class and override the
isCreateCamelContextPerClass method and return
true as shown in the following example: